E Catalogue

81 MICROCOAT LUBRICATION SYSTEM Specifications MC785M and MC785M-WF Valves Size: 66.3 height mm x 49.3 mm diameter (2.61" x 1.94") Weight: 206.4 g (7.28 oz) Lubricant chamber: Aluminum, hard-coat anodized Return spring: 303 stainless steel Lubricant inlet hole: 1/8 NPT Mounting: 6 mm tapped hole Air cap: 303 stainless steel Diaphragm: Viton ® with PTFE coating Needle and nozzle: 303 stainless steel Nozzle diameter: 1.17 mm (0.046") U.S. Patent # D-398, 705 All stainless steel parts are passivated. MC800 Controller Cabinet size: 14.6 W x 19.1 D x 27.6 H cm (5.75" x 7.50" x 10.88") Weight: 4.8 kg (10.62 lb) Air input required: 60 psi (4.14 bar) minimum Tank air pressure regulator: 30 psi (2.07 bar) maximum Nozzle air regulator: 30 psi (2.07 bar) maximum Cycle rate: Up to 60 per minute Pressure switch rating: 20VA, 240V Applications: Tube Forming Fine Blanking Rust Prevention Can End Pull Tabs Cooling Fin Forming Foil Rolling Coil Stock Slitting Valve/Wire Coating Blank Stock Coating The MC800 Series system operates up to eight valves. Precision flow controls permit the amount of lubricant applied by each valve to be adjusted independently. Valves can be mounted above or below the stock. When the MicroCoat system is initiated, steady air pressure supplied to the lubricant reservoir forces lubricant through the filter and flow controls, and out to the valves. As the press starts, a 3-way air solenoid activates the system. As the valves open, Low Volume Low Pressure (LVLP) air transfers a fine, consistent film of lubricant onto the stock surface.