E Catalogue

1 2 6 3 4 5 6 7 8 31 The main purpose of the foundation is to stabilize the machine as well as to increase the moment of inertia. The foundation thus positively influences machine vibration by reducing the amplitude of oscillation. It is wrong, however, to assume that any foundation large enough would eliminate all vibration problems. It is important that as much information as possible be supplied regarding the machine to be isolated, this will include machine size and weights, any dynamic features of its operation, location including ground type, condition where optimal performance is required and a vibration analysis of the machine and site conditions. A correct isolation between machine foundation and the surrounding area will result in trouble free operation. As a result of years of experience we have the necessary experience in this field. At your request we can offer all other related services including measuring of vibrations, planning and construction design. Illustration 1, 2, 3: Depositing of BILZ insulation plates (green) and padding of the spaces with mineral fibre insulation plates (sacrifice formwork). Illustration 4: Covering of the entire area first with PVC sheeting as used for construction work, and then with mineral fibre cover plates. All overlappings must be pasted/glued together. Illustration 5, 6: Mounting of reinforcement. Illustration 7, 8: Filling in of concrete. Application example in the plant of a major automobile manufacturer. Passive insulation protection of a Waldrich-Coburg portal milling machine from the pressing mechanism sector. Total mass: approx. 1200 to. 7 Foundation insulation 1 2 3 4 5 6 4 1 Foundation (side wall) 2 Mineral fibres and cover plates (lost formwork) 3 Foundation block 4 PVC film cover 5 Mineral fibres and cover plates (lost formwork) 6 BILZ insulation plates 7 Foundation (base) BILZ insulating plates are ideally suited for vibration suppression of foundations and baseplates Fundamentisolation with Air-springs: Equipment: vibration isolated Inertia Block (about 20 to.) on BILZ ® – Membrane – Air-Spring-System BiAir ® 4-ED with mechanic-pneumatic level control MPN-LCV-HF Special request: Because of surrounding machines, crane runaway etc. installation of an isolation system is difficult. Workpieces with ca. 10 ton. creates a large change in loading on the isolation system. To compensate for this, a high flow mechanic-pneumatic level control with level accuracy ca. 0.1 mm is needed. Isolated Foundations “Lost form working technology” Precast form, steel mould